| A Thread size | M3x0.5 |
| L Insert lengths | 6.5 mm |
| D1 Insert diameter | 4.8 mm |
| L1 Min.Depth Full Thread | 4.0 mm |
| Base panel material | Plastic |
| H Hole diameter | 4.8-4.9 mm |
| W Min. wall thickness | 2.9 mm |
| B Min. Bottom thickness | 3.2 mm |
| Materials | Brass |
| Surface Treatment | Cleaning |
| Installation Equipment/Method | Press-in Threaded Inserts |
How to insert a threaded insert?
Inserting a threaded insert involves several steps and the method may vary depending on the type of insert used (e.g. helical coil, keyed insert, or solid insert). The following is a general guide on how to insert a threaded insert:
Tools and Materials Required:
Threaded Inserts: Select the appropriate type and size for your application.
Drill and drill bits: For drilling the holes (if not already done). The drill bit size should match the blade specification.
Tapping tool: If the insert requires a threaded hole.
Insert Tool: Some inserts require specific tools to install.
Loctite or adhesive (optional): For added security, depending on insert type and application.
Steps to insert a threaded insert:
Prepare the hole:
If you are starting with solid material, drill the hole using a drill bit size that is appropriate for the blade. Make sure the hole is straight and clean.
If the insert requires a threaded hole, use a tap to create threads in the drilled hole.
Clean the hole:
-Clean out any debris or dust from the holes to ensure a good fit and bond.
Insert the threaded insert:
For Helicoil Inserts: Use the insertion tool to thread the helicoil into the hole. Make sure it is fully seated and flush with the surface.
For Solid Inserts: If it is a press-fit insert, you may need to use a press or hammer to gently tap the insert into the hole until it is flush with the surface. Make sure to apply even pressure to avoid damaging the insert or surrounding material.
For keyed inserts: Follow the manufacturer's installation instructions, which may involve screwing or pressing the insert into place.
Secure Insert (if applicable):
If using adhesive, apply it to the insert or hole before insertion. Follow the adhesive instructions to allow it to cure.
With some inserts you may need to use a locking compound to ensure the insert remains secure.
Final Check:
Make sure the blade is properly installed and aligned. Check for any misalignment or protrusions.
Test thread:
After installing the insert, test it by driving in the bolts or screws to ensure it is properly installed and secure.
Tip:
Always refer to the manufacturer's instructions for specific installation guidelines for the type of threaded insert you are using.
Use the correct tool to avoid damaging the blade or the substrate.
If you are unsure of the process, consider practicing on scrap materials first.
By following these steps, you can successfully insert threaded inserts into your material, providing a strong and reliable threaded connection.